Cisco 642-883 Exam Passing Guide

Cisco 642-883 exam dumps are the one of the best preparation methods to pass the CCNP Service Provider Certification exam. Multiple professionals made these 642-883 exam dumps with accurate knowledge to attempt questions of Deploying Cisco Service Provider Network Routing topics in the first attempt.

Try it Latest DumpsSchool 642-883 Exam dumps. Buy Full File here: https://www.dumpsschool.com/642-883-exam-dumps.html (130 As Dumps)

Download the DumpsSchool 642-883 braindumps from Google Drive: https://drive.google.com/file/d/1_swVASnjpzbO29A8yqMKYn5nkpVYcD0L/view (FREE VERSION!!!)

Question No. 1

Which statement is correct regarding the DR election process In this OSPF implementation?

Answer: A

# show ip ospf neighbor

# show ipv6 ospf neighbor

Question No. 2

Refer to the network diagram in the exhibit.

If both ASBRs are advertising the external Destination X network as OSPF E2 route, what is the best path for the R1 router to reach Network X?

Answer: B

Question No. 3

Which two of the following are true regarding the BGP Prefix-Based outbound route filtering feature? (Choose two.)

Answer: A, B

http://www.cisco.com/en/US/docs/ios/12_2s/feature/guide/fsbgporf.pdf

Restrictions for BGP Prefix-Based Outbound Route Filtering

* The BGP Prefix-Based Outbound Route Filtering feature does not support IP multicast routes.

* IP addresses that are used for outbound route filtering must be defined in an IP prefix-list. BGP distribute lists and IP access lists are not supported.

* Outbound route filtering is configured on only a per-address family basis and cannot be configured under the general session or BGP routing process (Router(config-router)#).

* Outbound route filtering is configured for only external peering sessions.

Question No. 4

Refer to the show command output in the exhibit.

For which reason will this router drop all traffic that is destined to the 1.1.1.0/24 network?

Answer: B

Question No. 5

Which option describes howan engineer must configure route summarization on a Cisco IOS XE OSPF-enabled network of routers?

Answer: A

Question No. 6

Refer to the exhibit.

R1 and XR2 cannot establish OSPF adjacency. Which option is the root cause of this issue?

Answer: D

Question No. 7

An engineer wants to define a route policy that sets MED to a given value in case the extended community attributes of a network prefix match at least one of the values: 65000:10, 65000:20, or 65000:30. Which configuration accomplishes this task?

Answer: B

Question No. 8

What are three common problems that can cause a BGP neighbor state to toggle between the idle state and the active state? (Choose three.)

Answer: C, E, F

Question No. 9

Which configuration implements the most secured OSPF authentication mode on Cisco IOS XE?

Answer: A

642-883 Dumps Google Drive: (Limited Version!!!)
https://drive.google.com/file/d/1_swVASnjpzbO29A8yqMKYn5nkpVYcD0L/view

Related Certification: CCNP Service Provider dumps

         

Facebook Comments